Product Supporting Documentation. If you need to find any of our documents, they should be in this list below. Here you will find installation guides, brochures and user guides. If there is something you need that you can't find here, please call our Customer Services department on. Drayton digistat 3 old model instructions. Drayton lp522 manual pdf. Drayton digistat+2 problemsdrayton digistat 2rf Mains – Digistat Have searched the internet but cant find anywhere to download instructions for. Drayton digistat RF2 Wireless system if anyone has one do. • Clock Setting display is flashing and shows. Display is flashing and shows. Your Digistat +3RF is fitted with a real-time clock, which is pre-set Thermostat Wireless at the factory. You will not have to alter the time settings. A special feature of this real-time clock is to automatically update 2. • 21°C where it stays until 23:00 when (Fig 6) (Fig 7) buttons for 2 mins will cause the Digistat +3RF to return to Auto. The temperature drops down to a setback temperature of 10°C (Fig 5) shows option 01 24 (24 hour clock). Page: 0 14.Continue to press “SET?” button until you return to normal operating mode with a display similar to the one shown here. OPERATING MODES The Digistat can be operated in one of three modes. 1) – Timed, all preset times and temperatures 2) – Continuous night temperature (useful for low limit temperature protection when on holiday) 3) – Continuous ‘DAY 1’ temperature Use the SELECT button to change the operating mode to suit your requirements, the symbols are positioned on the right hand side of the display. TEMPERATURE OVERRIDE If at anytime during normal operation, you wish to temporarily increase or decrease the set temperature use the + or – buttons to change to your desired setting. This can be done without entering the SET mode. Five seconds after releasing the + or – button the display will revert to showing the actual room temperature. The Digistat will now control the temperature to the override setting until the next programmed switching time, when it will revert to the times and temperatures you have already programmed. BATTERY REPLACEMENT 30 days before the batteries need re- placing, a battery symbol will flash in the right hand side of the display (Diagram C). Acer travelmate 2301 lmi drivers manual. This signifies that two 1.5V type AA alkaline batteries will be needed to replace the existing ones. If battery replacement is carried out in this condition the programmed settings will only be held in the memory for a maximum of one minute, after which re-programming may be necessary. IMPORTANT To avoid the possibility of having to re-programme the switching times and temperatures, it is advisable to wait until the display with a flashing battery symbol changes to a continuous battery only display (after 30 days Digistat 3i User instructions – Diagram D). In this condition the unit will remain OFF but your programmed settings will be held in memory for a number of weeks. The battery compartment can now be left open, to replace the batteries, for approximately one hour. If the compartment is left open for longer, the unit will revert to the factory preset times and temperatures. It may be necessary to reset the correct time of day after changing the batteries. The battery compartment is situated at the bottom of the unit (press to unlatch and slide down). Ensure new batteries are installed correctly. HELPFUL HINTS 1) First/Last Set Times The Day 1 setting cannot be programmed before 12.00 midnight. The night setting can be programmed at whatever time you require, even after 12.00 midnight so long as it is not programmed more than 23 hours 50 minutes after the Day 1 setting. 2) Part or Full Day Omission If during programming the Digistat, one of the symbols on the left hand side of the screen starts to flash, this indicates that two or more of the switching times have been set to the same time. This facility enables you to omit one or more of the switched periods.
0 Comments
Leave a Reply. |